Support
- Total activity 404
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 371
Activity overview
Latest activity by Support-
Support created an article,
Can I use carbide blades for interrupted cuts like angle and tubes?
No, carbide blades are very hard but not shock resistant. Bi-metal blades are far superior for interrupted cuts.
-
Support created an article,
Which LENOX blade will cut stainless steel?
Lenox bi-metal and carbide blades will cut steel. Successful machining of stainless steels depends on proper speeds and feed.
-
Support created an article,
What is the dilution ratio for Band-Ade and SawMaster?
The recommended dilution ration is 10:1
-
Support created an article,
What is a Micronizer?
A Micronizer is air propelled misting unit that applies precise amounts of sawing fluids.