Support

Total activity 404
Last activity 02 July 2024 15:41
Member since 27 April 2021 21:40

Following 0 users
Followed by 0 users
Votes 0
Subscriptions 371

Articles

Recent activity by Support

Can I use carbide blades for interrupted cuts like angle and tubes?
1. General
No, carbide blades are very hard but not shock resistant. Bi-metal blades are far superior for interrupted cuts.
- Support
- 04 January 2023 20:47
- Updated
- 0 followers
- 0 comments
- 0 votes
Which LENOX blade will cut stainless steel?
1. General
Lenox bi-metal and carbide blades will cut steel. Successful machining of stainless steels depends on proper speeds and feed.
- Support
- 20 May 2021 04:09
- Updated
- 1 follower
- 0 comments
- 0 votes
What is the dilution ratio for Band-Ade and SawMaster?
1. General
The recommended dilution ration is 10:1
- Support
- 04 January 2023 20:50
- Updated
- 1 follower
- 0 comments
- 0 votes
What is a Micronizer?
1. General
A Micronizer is air propelled misting unit that applies precise amounts of sawing fluids.
- Support
- 20 May 2021 21:32
- Updated
- 1 follower
- 0 comments
- 0 votes